Login | Register RSS

Use Multiple Wireless Routers-Access Points On Same Network

Here is how to network 2 routers (hardwire & wireless routers) into a single home network, connected to a cable modem.

Simple Setup Overview:

You should not need to adjust your hardware router in any way.
The hardwire router should work immediatly upon being connected to your cable modem.

You will however make 2 adjustments to the wireless router, before connecting it.
In the wireless router, disable DHCP & change the IP to '192.168.1.2'.

Layout of hardware connectivity when completed:
-- Wall Socket (Coax connector) to Cable Modem (Coax connector)
-- Cable Modem (LAN port) to Hardwire Router (WAN port)
-- Hardwire Router (Uplink/LAN port) to Wireless Router (LAN port #1)

What this does:
-- allows the hardwire router to do all the DHCP work
-- allows you to connect both routers in a way which creates a single network
-- allows you to use your wireless router, as an extra network switch & wireless access point
-- should allow you to use the better switching abilities & packet management of your
hardwaire router, while not loosing wireless functionality
-- simplifies your network layout, when using 2 routers at the same time

What you need to do:
-- power down all of your equipment
(PCs first, vonage device second, wireless router third, cablem modem last)
-- swap out your wireless router, with your hardwire router
-- power up all your connected equipment
(cable modem first, hardwire router second, vonage device third, PCs last)
-- ensure you can connect to the internet on your PCs and your vonage phone works
(if you have connection problems, try resetting the hardwire router to factory defaults)
-- If everything works normally, then perform these steps seperately:
==> power up the wireless router, without connecting it to your network
==> connect one of your PCs to any of the wireless router's LAN ports (not the WAN port)
==> boot-up that PC
==> in your PCs browser, login to the admin area on your wireless router
(the wireless router's admin area should be located at IP '192.168.1.1' or '192.168.0.1')
==> in the wireless router's admin area, change the routers IP to '192.168.1.2'
==> if the DHCP option is not on the same admin page, you will need to save the change &
then login again to your wireless router at IP '192.168.1.2'
==> now disable the DHCP option in your wireless router's admin area.
==> save the change, then power down your PC & the wireless router
-- now that the wireless router is all configured, we can finish up things
-- connect an ethernet cable from the hardwire router's uplink port (if you have one) or LAN port #1
(if you don't have an uplink port) to the wireless router's LAN port #1.
-- power up your wireless router and you're all done. :-)
-- at this point, you simply test your wireless connection, which should work normally.
(no changes should be required to your wireless PCs configuration)

 

When you want to admin your routers:
==> goto IP '192.168.1.1' to access the hardwire router's admin area
==> goto IP '192.168.1.2' to access the wireless router's admin area

If you like this site or any of its content, please help promote it. Use the social media buttons below to help spread the word. Don't forget to post in the comments section.

  Print   Email
Latest Blog Posts:
Latest Q&A Posts:

© 2017 BuildDesignCreate.com • All Rights Reserved
Privacy PolicyAdvertise with UsContact UsSite Map